Double Bridle Bits

[Scottish_Miss]

Hi

Quick question about the fitting of double bridle bits - they are not suppose to touch each other - or so I was lead to believe. However when fitting mines the middle part
(bridoon lozenge ) I'm sure touches the weymouth, although this was at rest and with contact prob not! Did not have help to see if that was case.
If I drop the weymouth down a hole it does look far too low.

Any input>?

 

[Cortez]

In general the bridoon sits a bit higher than a normal snaffle and the curb a little lower than, say, a pelham would. Hard to tell without a picture.

 

[Scottish_Miss]

Ok First 2 pics were from last week - this I think shows weymouth too low:-

http://s295.photobucket.com/user/ScottishMiss/media/Picture001-1.jpg.html

http://s295.photobucket.com/user/ScottishMiss/media/Picture002-1.jpg.html



These 2 from last night - but when insert finger the middle of bridoon does touch weymouth??

http://s295.photobucket.com/user/ScottishMiss/media/Picture003.jpg.html

http://s295.photobucket.com/user/ScottishMiss/media/Picture004-1.jpg.html

 

[Scottish_Miss]

Pics now included - any advise appreciated

 

[Scottish_Miss]

Any thoughts now have added pics?