Height of tow ball on Discovery please

Bryndu

Well-Known Member
Joined
30 July 2008
Messages
1,192
Visit site
Hi,
Does anyone know what height the tow ball should be set on a Landrover Discovery with springs not airbags...to pull a two horse trailer?
Thanks
Bryndu
 

popsdosh

Well-Known Member
Joined
7 November 2008
Messages
6,388
Visit site
Hi,
Does anyone know what height the tow ball should be set on a Landrover Discovery with springs not airbags...to pull a two horse trailer?
Thanks
Bryndu

To state the obvious where ever it has to be to make the trailer ride level . EU standard is 350-420mm measured to centre of towball with a laden vehicle . however with a twin axle horse trailer it is critical that within reason the axles are carrying an even load allowing for being slightly nose heavy. This then gives the least chance to get snaking which discoveries can be prone too.
Vehicle dynamics make it a lot safer if the balance point of the load is slightly forward of the trailers balance point.
 
Last edited:

Bryndu

Well-Known Member
Joined
30 July 2008
Messages
1,192
Visit site
Thanks for this popsdosh..
I ask because the book of the Landrover says to have it way over the heights that are mentioned above.
Best wishes
Bryndu
 

Tiddlypom

Carries on creakily
Joined
17 July 2013
Messages
24,120
Location
In between the Midlands and the North
Visit site
As Popsdosh post. Also, our Shogun towball has a choice of two height fitting options at either 350 or 420mm, and my Ifor 510 sits much better when it's at 420mm rather than at the lower setting, so it does depend on the trailer too.
 
Top