Liveryman stallion clippers

The blades are held in place by two screws. Firstly,turn the machine upside down so you are looking into the head. You will see a rectangular block, held between two leaf springs. This carrier has two small triangular pyramids on it. Take you small blade and drop it onto the two pyramids so they locate in the small holes on the top of the blade. Put some oil on the blade,then put the large blade on top of the small one. Tighten the two big flat screws, to hold the blade in place. Carefully wind the tension up a bit until it just pinches the blades together then turn the machine over,turn it on and tighten the tension until you here the note of the blades change, at ,or about this point tension should be set for clipping.
 
You must log in or register to reply here.
Top