Myler Bits

[Montysmum]

Hi everyone

I have been looking at Myler bits and noticed that some people say that they come up big compared with other bits (widthwise). Anyone found this or should I just order the same size as he is in now?

 

[Kokopelli]

I found it normal size.
Perhaps when you buy measure it against yout current bit?

 

[Fuzznugget]

I've not noticed a difference in sizing between my Mylers and the other bits. I agree with the suggestion of measuring it against your current bit, but they should be the same size.

 

[Eriskayowner]

I think that they are marginally wider, but I'd rather have a bit too wide than too narrow. Again, as above, check against your current bit when it arrives, or go to a tack shop with your current bit and see how it comes up.

 

[Meowy Catkin]

I personally found that they come up 1/4 inch bigger, so you could buy your normal size and put bit guards on the bit if needed.

I think the reason that they come up large is because they (Mylers) are already bent where as a 'normal' snaffle is measured straightened out. Eg, my loose ring lozenge snaffle measures 5 inches between the rings when it is straight, but when it is in the horse's mouth it is slightly bent and therefore the width between the rings is under 5 inches when in use.

I hope that makes sense.